What did you just do to your Sherco?

[jpgibson]

Took a turn out of the three Id put on the shock preload, replaced two linkage bearings and greased the rest. There was NOT a lot in there and the bike only has 24h on it. Now all I need is for my shoulder to improve....

[OMC]

Changed exhaust flange O-rings, checked powervalve cable tension, softened suspension ...I hope I didn't wind the clickers out too far...
Straightened valve stem, tightened rim lock, fuel, air, ready to ride

[Roon]

Originally Posted by jpgibson

Took a turn out of the three Id put on the shock preload, replaced two linkage bearings and greased the rest. There was NOT a lot in there and the bike only has 24h on it. Now all I need is for my shoulder to improve....

put some grease in it, I think all yours has gone dry....

[AndrewH]

Installed Radiator Braces, Installed Pivot Brake and Clutch levers and put on carbon pipe guard didn't have time for the bark busters so ride tomorrow with out them.

[shawbagga]

Originally Posted by AndrewH

didn't have time for the bark busters so ride tomorrow with out them.

Best ya jus order in a new master cylinder now after that statement Andy!

[gasser_neil]

Took air filter out to clean. Not much else needs be done apart from ride..

Sent from my HTC_0P6B6 using Tapatalk

[eagle]

Put a new front sprocket & front tyre on ready for some rides, haven't ridden at all yet this year so i'am looking forward to see how the new Star cross 5 will go!

[brookes2622]

Originally Posted by eagle

Put a new front sprocket & front tyre on ready for some rides, haven't ridden at all yet this year so i'am looking forward to see how the new Star cross 5 will go!

Lovin my SC5 on the rear.

[jpgibson]

Greased my headstem bearings- not really needed as they were well greased!

[chris250]

Bump started it,
Then headed back to the cars.

It has an electrical problem, & no kickstarter.