![]() |
#11
|
||||
|
||||
Does that mean it is a metal gasket? What implications does this have on resetting squish?
|
#12
|
|||
|
|||
They are rubber o rings.
|
#13
|
||||
|
||||
#14
|
||||
|
||||
So my mate is copping flak for wanting to check his squish first before jetting. How likely is he to find bad squish measurements? How much difference does setting up the squish actually make?
|
#15
|
||||
|
||||
I thought setting squish was step 1?
__________________
'18 GG XC250! |
#16
|
||||
|
||||
I'd say step 0 actually. It's being done.
|
#17
|
||||
|
||||
#18
|
||||
|
||||
Haha ya jerk
![]() I did the other day on new 125 top end. 1.2-1.3mm as using 0.8mm base gasket. Bit big but will chuck the 0.3/4/5mm base on for next piston to get it down to 1mm 300 never really bother with but will next top end(soon) & 165 was already pre set
__________________
'18 GG XC250! |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
My first Sherco | brookes2622 | Sherco Forum | 6 | 31-08-2015 10:04 PM |
Sherco 2015 300 SEF-R, 300 SE-R and 450 SEF-R impressions & review - Sherco Ride Day | mr bergman | Sherco Forum | 20 | 17-08-2015 02:02 PM |
sherco | kwakas | Bikes & Quads | 0 | 24-06-2015 10:12 PM |
Sherco | BIGBADAL | General Bike Related Discussion | 2 | 29-06-2007 11:33 PM |
Jetting a 05 525.......Yes, Another Jetting Thread! | PaulyT | KTM Forum | 14 | 07-03-2007 06:45 AM |